Outdoor IP Cameras
Network cable joining near bullet cameras or installation points exposed to moisture, with correct closure and sealing.

The KONGIA KG-RJ45-CP-C6-U-IP67-WH joins two Ethernet cables through an RJ45 female-to-female connection inside a housing with threaded closures and seals at both ends. Intended for outdoor or damp-location LAN and IP/CCTV camera connections. This version is unshielded UTP.
The KONGIA KG-RJ45-CP-C6-U-IP67-WH joins two Ethernet cables through an RJ45 female-to-female connection inside a housing with threaded closures and seals at both ends. Intended for outdoor or damp-location LAN and IP/CCTV camera connections.
This version is unshielded UTP. Its ABS housing and eight contacts connect compatible Cat6, Cat5e and Cat5 cables. The reference material specifies Gigabit and PoE use, with performance subject to link cabling and equipment. It is a passive coupler and does not increase the network's maximum distance on its own.
Stated IP67 protection requires all gaskets to be installed, the seal to fit the cable and both ends to be correctly closed. Check that the RJ45 connector passes through the sleeve: bulky molded boots may prevent assembly.
Available in white; select a pack of 1, 2, 3 or 5 units. Each pack contains complete assemblies of the same color. Installation images show cables for reference only.

Network cable joining near bullet cameras or installation points exposed to moisture, with correct closure and sealing.
Replacement or extension of a section with compatible RJ45 connectors without changing the entire route.
Protection of an Ethernet joint against dust and moisture within the stated scope and with proper installation.
Selection of packs of 1, 2, 3 or 5 units for multiple connection points.
Get preferential commercial terms, stock availability and specialist technical advice for your installation.
Download the official datasheet and certified PDF resources for projects and tenders.
Quick answers to help you select and request this product.
No. It is unshielded UTP and does not provide electrical continuity to an STP cable's shield. Select a shielded coupler if your installation requires that continuity.
Two RJ45 female ports with 8 positions and 8 contacts. Connects two Ethernet cables with compatible RJ45 male connectors.
Cat6, Cat5e and Cat5 with compatible terminations. Final speed depends on the complete link's category and condition, not just the coupler.
The selectable quantity is 1, 2, 3 or 5 units. Each pack contains a single color: white. The cables shown in the images are not included.
No. Stated protection applies to the assembled unit, with correct gaskets and seals and tightened nuts. An open end or improperly sealed cable is not protected.
A bulky boot or protector may not pass through the sleeve. Review the image guide and check fit before installation. The reference material shows an RJ45 without a bulky boot as a compatible option.
The supplied material specifies PoE compatibility. It is a passive component: it does not generate power. Check the class and power required by the camera, cabling and PoE source.
1000 Mbps theoretically equals 125 MB/s before protocol overhead. This is not a download speed guarantee; performance depends on the entire network.
No. It joins cable sections but does not regenerate the signal. Total length remains subject to Ethernet installation limits.
The material does not provide a verifiable range. The 21 mm measurement refers to the outer body. Verify that the seal fits the cable used.
KONGIA 5-year warranty.
Our team can help with quotations, availability and technical support for distributors.